•
1 6

SKYMONSTER-RC

Urltra-Light FPV Fiber Optical Video Data Module Anti-interference Relay Extender Optical Link Sky Support up to 20km

Urltra-Light FPV Fiber Optical Video Data Module Anti-interference Relay Extender Optical Link Sky Support up to 20km

$94.78 USD
$94.78 USD
Sale Sold out
Shipping calculated at checkout.

TX Module (sky Terminal) sky System

Input voltage：5-26V

Size：50mm×29mm×13mm

Weight：15g

power consumption：<5W

 

RX Module(Ground Terminal) Ground terminal

Input voltage：4S-6S with XT60

Size：50mm×29mm×13mm

Weight：15g

 

2、 Technical specifications

1.Maximum rated specified range

• Transmission distance: 20 kilometers (standard configuration), customizable up to 100 kilometers

• Working temperature:- 40℃~+85℃

• Storage temperature:- 40℃~+85℃

Humidity range: 5%~95% (no condensation)

• Working voltage: 5-28V

2.Typical Recommended Parameters

Video input/output: Pin (MX-SH1.0mm-5P)

Fiber optic interface: default FC type (SC/LC/FT port)

• Communication interface: UART/TTL/SBUS( MX-SH1.0m

 

interface definition

• Sky end (TX/A):

TX/RX/GND/VCC/AVI/GND (MX-SH1.0mm-5P interface, CVBS video input)

FC fiber optic interface

Ground end (RX/B):

TX/RX/GND/VCC/AVO/GND (MX-SH1.0mm-5P interface, CVBS video output)

FC fiber optic interface


instructions

1.Wiring steps:

Sky end: Connect the CVBS output of the drone camera to the video input port of the optical terminal, connect the RX to the CRSFTX of the flight control, and connect the TX to the CRSFRX of the flight control

Ground end: Connect the display/control station to the video output port of the optical transceiver, connect the RX to the CRSFTX of the remote control receiver, and connect the TX to the CRSFRX of the remote control receiver

Use FC fiber optic jumpers to connect the two ends of the optical ports

2.Power supply requirements:

◦ It is recommended to use a stable power supply of 5V-28V for power supply

◦ Avoid sharing ground with strong electrical equipment

3. Precautions:

The bending radius of the optical fiber should be ≥ 30mm

It is recommended to use single-mode fiber optic for long-distance transmission

Regularly clean the fiber optic interface end face

View full details

Featured collection